Your location:  Home  >  Bearing News  >  World Bearing News
<<  Back

3x3 Puzzle Cubes with Gears

Resource from:  https://www.powertransmission.com/ Likes:68
Jul 10,2020

6.png

Looking at a Gear Cube XXL, you can’t help but think about a Rubik’s Cube. Both are 3×3 puzzle cubes with brightly colored pieces. Moreover, both are sold commercially as toys. Created by Oskar van Deventer, the Gear Cube XXL and the smaller Gear Cube are made by Mefferts, a brand of puzzle toys, and are distributed by Recent Toys, Amsterdam, The Netherlands. You also can’t help but notice that Oskar’s cube is different from a Rubik’s. On Oskar’s cube, the pieces have gear tooth shapes on them. This difference goes deeper than the surface. The shapes are actual gear teeth that extend into the puzzle’s interior and that mesh and roll with each other. So, even though it looks like a Rubik’s Cube, Oskar’s cube works quite differently. To understand how Oskar’s cube works, though, you have to start with a Rubik’s Cube. Holding a Rubik’s in your hands, looking at a side, you see nine pieces. The pieces form three columns: a left, a middle, a right. Each column has three pieces. When you work the cube, you turn one column, say the right column, while you hold the left and middle columns steady. With Oskar’s cube, when you turn the right column, the middle column also turns. Now, both columns turn in the same direction, but the middle one turns at half-speed. So, if you do two full turns of the right column, the middle column will do one full turn. Also, because the teeth mesh and rotate, they end up with a different orientation than they had when you started turning the right column. So, you’d have to do many double full turns of the right column to compensate for the turning of the middle column. With all that turning, meshing, and rotating, you may think Oskar’s cube would be hard to solve. “It looks very difficult,” Oskar says, “but it is actually easier to solve because the gears limit how far one can scramble it.” From the start, the gears were the special part, the wrinkle, in the cube’s design. Back then, the cube was a design challenge between friends, an impossible design challenge.

(https://www.powertransmission.com/)
【CBCC News Statement】
1.The news above mentioned with detailed source are from internet.We are trying our best to assure they are accurate ,timely and safe so as to let bearing users and sellers read more related info.However, it doesn't mean we agree with any point of view referred in above contents and we are not responsible for the authenticity. If you want to publish the news,please note the source and you will be legally responsible for the news published.
2.All news edited and translated by us are specially noted the source"CBCC".
3.For investors,please be cautious for all news.We don't bear any damage brought by late and inaccurate news.
4.If the news we published involves copyright of yours,just let us know.

BRIEF INTRODUCTION

Cnbearing is the No.1 bearing inquiry system and information service in China, dedicated to helping all bearing users and sellers throughout the world.

Cnbearing is supported by China National Bearing Industry Association, whose operation online is charged by China Bearing Unisun Tech. Co., Ltd.

China Bearing Unisun Tech. Co., Ltd owns all the rights. Since 2000, over 3,000 companies have been registered and enjoyed the company' s complete skillful service, which ranking many aspects in bearing industry at home and abroad with the most authority practical devices in China.