The natural rubber "Finger-Flex" ring and bushing in each mount have radial fingers on top and bottom surfaces to absorb vibration parallel to the axis of the mounting.
The bushings also have axially-orientated fingers which enable the mounting to absorb vibration perpendicular to the axis of the mounting. To obtain optimum isolation efficiency there are two hardnesses of V10Z 4 Series Finger-Flex Mounts available: 30 and 60 durometer. The natural frequencies of the V10Z 4 Series mounts range from 6 to 30 Hz.
"Finger-Flex" washers can be stacked in series and will yield an assembly with greater deflection. Any number of "Finger-Flex" mountings can be installed in parallel to achieve greater load carrying capacity.
Other features of the V10Z 4 Series include their corrosion resistant zinc plated housing and low 1-1/8", free standing, height. The 2-3/8" square base dimension and 4-hole tie-down pattern conform to MIL-Size 2. The load is supported by the top surface of the housing which has a 17/64" clearance hole in its center to accommodate a locating stud.
Next AAC’s New Isolators Designed for Vibration and Noise
BRIEF INTRODUCTION
Cnbearing is the No.1 bearing inquiry system and information service in China, dedicated to helping all bearing users and sellers throughout the world.
Cnbearing is supported by China National Bearing Industry Association, whose operation online is charged by China Bearing Unisun Tech. Co., Ltd.
China Bearing Unisun Tech. Co., Ltd owns all the rights. Since 2000, over 3,000 companies have been registered and enjoyed the company' s complete skillful service, which ranking many aspects in bearing industry at home and abroad with the most authority practical devices in China.
